Product Reviews

Outrageous price for a semi-useful device. What is this, 25 cents worth of plastic? It is not easy to use, and I was forced to go down to five rounds at a time to get it to work. The front of the bullet struck against the lip of the mag and would keep all other shells from going in. Had to push the tip of the stuck bullet backwards into the mag, then push again to get maybe a couple more shells into the mag. I did not use a strip, but loaded the shells loose in the loader. Too much trouble for its value, and way over priced. Disappointed. You could never use this in the field under fire. It took me over two hours in a recliner, taking my time, to load ten 30 round AR mags.

DAA reply:
Hi Alan,
Sorry you had such a poor experience using your Striplula.
You are mistaken to think this is a product which costs 25 cents to produce though. And besides, what you are paying for is not only the product, but the product development. While your experience in using it was not good, this is the most successful product of its kind, as is attested to by the many awards it has won, and the many many tens of thousands sold by Maglula, the Israeli Manufacturer.

the tool holder does not fit the tube for the case feeder on my XL750, its loose, I had to wrap the tube with tape to use the holder. The wrenches don't hang straight in holder the holes in the holder are just a smidgen to large, a small beef but it bugs every time I look at it. The wrenches have a ball end that's a good thing but they don't work well, they bind up if uses at an angle, like the chrome plating is out of spec, just a little thick. I end up using my Bondhus set instead quite often. The closed end wrench works well but not on the powder measure, it wont go over the measure, an open end wrench would work better. All in all I wish I had purchased the Dillon set.

DAA reply:
Hi Kim,
Make sure the pole square-to-round adaptor is insert from below. It makes the fit tight on the round rod and prevent slide. But, as you have done, a little tape does solve that too
The wrench is a box-end wrench, closed design, as clearly shown. it must be closed to allow it to be so thin. And keeping it thin is critical to fitting in between the dies. cant have it both ways…. But sure, it does not fit over large items like powder checks. For that, you still do need an open end wrench.

this works very well, simple to use. combine it withe the feeder bowl and I don't need a $300 case feeder.

This loader bowl works well. I have been loading 6.5 Grendel, using the bowl set up for .223. The Grendel round uses the same parent case as the 7.62X39 so I was hoping it would feed the 6.5 cases, and it does. Just throw some cases in the bowl while the whole thing is sitting on the press and give it a swirl, the cases drop in just fine. This system is a better option than the Dillon case feeder for me, it's simpler to use and saved almost $300 on equipment.

Great training aid ... Well built , easy to install ..

Great gear, had one for .40, needed one in 9mm.. easy install and setup.