Read What Others Are Saying

As previously stated, I did have to clean hopper with a plastic polish to get primers to stop sticking, ( I used Plexus ) and I had a lot of trouble with the vibration not effectively getting primers to flow properly. Directions stated that I might have to loosen screws holding hopper to base. Many attempts later I finally has to slip a piece of thin plastic under mounting points. I used a tiny hole punch to make hole in plastic then cut plastic squares to fit between hopper and base finally allowing primers to feed properly. I still don't really trust them to be entirely right side up, so I stand and observe primers as they feed. As I get more comfortable with unit I may be able to trust it. It does seem to be operating as intended, but the jury is still out...

So much easier . It's a welcome addition to my press's RL1050 and RL 750

This is the greatest addition to the MrBulletfeeder. Reliably feeds on bullet at a time.

the magazines fit perfectly in my CZ Shadow 2, very useful for dry fire. The weight simulates a full mag

the magazines fit perfectly in my CZ Shadow 2, very useful for dry fire. The weight simulates a full mag

the magazines fit perfectly in my CZ Shadow 2, very useful for dry fire. The weight simulates a full mag

What a great idea. Much easier to adjust then the puck system. This should be included standard with the unit.

the magazines fit perfectly in my CZ Shadow 2, very useful for dry fire. The weight simulates a full mag

very satisfied with the purchase, in 2 hours at the most I can get the cases perfectly dry. For the perfectionists .... if you do not want to have some unsightly stain due to calcareous water, the last rinse must be done with distilled water

20 holes, but not uniform in size. A good idea with a sub-optimal execution. Ended up disappearing into a drawer.

Looks nice, does not really through enough light. Would be nice if it could be brighter.

Shipping was faster and much less expensive than Dillon. Great company.

Like the thumb screw handles, only issue is since it was installed now have heads falling in upside-down. Still love the product, not sure about the minor issues though.

Works great with the bullet feeder! Gotta have it!

Arrived today 9/3/21 12:30.
Mounting and assembly was no problem at all.
Had to do some adjustment to the primer system, primer was not seating fully and primer shuttle was out of alignment. Fixing the seating problem was dead easy but fixing the alignment took a long time and was a pain in the ....
The spent primer tube arrived flat, not even a small primer would pass through it, another pain in the .... to fix. Hair drier and a rod pushed inside fixed that.
So no 5 stars.
Setting up the dies and powder measure is the same as any other press.
By 19:00 had the press working smoothly.
Now I need a bullet feeder????

Works great, no spilled powder anymore when reloading 9mm.

Recently purchased a Shotmaxx-2 Case. Fast shipping, and great product. The SHOTMAXX-2 Watch Timer fits perfectly in the case including the USB charging cable. I recommend this hard case for protection and easy handling.

Recently purchased a Shotmaxx-2 Watch Timer. As usual, shipping was fast and the product is great. It has worked very nice for dry fire practice at home. Unfortunately I was not able to use it with live ammo. Ranges are still closed as a result of COVID.
It would be perfect if there is an interface to export the stored data (CSV's) into a computer/ spreadsheet for further analyses. Therefore not the maximum star rate.

Great product easy to set and reliable. I installed mine on a Hornady AP had to modify by shorting a couple threads.

Aangekocht in .45acp en zeer tevreden mee. Snelle levering.