Product Reviews

I love these pouches for IDPA. They hold my Walther mags tight, but glide out smoothly for reloads. Would love to see a clip-on belt option for ease of install and removal outside of competition to make them more EDC friendly.

I received my Mr. Bulletfeeder Pro recently and love it. I had a little trouble with the dropper, contacted support and they emailed me the next day with a solution. I moved the ball bearings from the upper to the lower and that did the trick. I have a Dillon 1100 and it seems slow as a turtle trying to load without a bullet dropper. Well worth the money.

When I purchased the Mr. Bullet Feeder for 9mm I had envisioned using it for the multiple other calibers I reload for as well. However after the setup and fiddling with the shims and spacers to get it to feed smoothly, I was reluctant to change over to another caliber as I didn't want to have to re-do all of the work getting the 9mm to feed right. The Pre-Set nose guide solves that problem by allowing you to set all of the parameters for a bullet type and then slide it out and slide in a new one for a different bullet type and or caliber. This invention has opened the door to using the Mr. Bullet Feeder for all of the calibers and bullet types I use. Well done!

Replaces original buckle of the Lynx belt quite easily. Excellent on holding the outside belt firm on the inner velcro belt. Applies pressure as needed..very clever...

I noticed a couple of the guys at my club had these ratchet buckles on their linx belts as I was struggling with keeping my original buckle fastened. Bought one immediately and am glad I did. Very easy to install and way more secure.

I think this is one of the best buys I've made for loading 223, but I had one issue that I think could of been designed better and I have sent an email to Lyman/Mark 7 about this. The hole in the trimmer die adapter is around 25,5mm. The guide on the trimmer body(motor) is 25mm and the chuck(for the end mill) is 24,8-24,9 mm. Chuck being almost as wide as the guide on the motor really makes the guide useless. If I just put the trim die adapter on the trimmer body and tighten the screws the chuck will hit the die adapter inside. So that's why only 4 stars. For myself I ended up using a lathe and turning some more room for the chuck inside the trimmer die adapter and making ring around the guide so that the trimmer body and the adapter would have a snug fit. Anyways trimming has been a pain in my neck for a long time and this just makes it effortless. I also highly recommend using Lyman M-die or similar afterwards since this does not deburr cases. Helps a lot when using soft bullets eg. Hornady 55gr FMJ-BT.