Mini Mr.BulletFeeder - 6-tube Magazine - Pistol

Double-Alpha Academy

Key features

Limited to €3,000 / Countries
€2.00 Reward points
Save for Later
 Item in Stock | Usually dispatched within 24 hours

Latest reviews

richard ***
6 Feb 2021
makes loading much faster , will be getting a few more
Rating: (5 of 5 Stars!)
David ***
22 Jan 2021
Works flawlessly. Very pleased with my purchase. A great addition to my 750xl.
Rating: (5 of 5 Stars!)
Kevin ***
18 Jan 2021
Once you get it set up it works great. One thing I did was take a white paint marker and mark the outside of the bottom where the hole is located. I also marked the tube with the pin, so it is easier to find. My only issue is the tube is hidden by my powder measure on my 550, so I have to keep...
Rating: (5 of 5 Stars!)
Dwight ***
29 Dec 2020
This is a simple, well-constructed product. It simply works without needing to screw around with it. It holds 100 bullets, which is a good number as a balance between weight, the time required to fill it, and the amount of time saved by not placing each individual bullet when reloading.
Rating: (5 of 5 Stars!)
Anthony ***
26 Dec 2020
Great feeder, but I made it much easier and faster to load by dropping the bullets nose down. Just put a cap on the top (spray can plastic top) and turn it upside down and dropped the bullets in nose first rotating the magazine as you go.
Rating: (5 of 5 Stars!)
Edward Ruiz ***
11 Oct 2020
As a person with arthritis in both hands I was looking for a solution to the problem of setting the bullets by hand. I didn’t want to spend $300 - $400 on the Mr. Bullet Feeder,
So I thought after seeing the mini in service, I decided to order my first kit in .40

After that worked out so well I...
Rating: (5 of 5 Stars!)


Get an additional 6-tube Magazine assembly for your Mini Mr.BulletFeeder by DAA. Each assembly will allow you to preload another 100 bullets before you start your reloading session.

Be sure to keep the assembly upright once filled, to prevent the bullets tipping out the top holes. Align the hole in the base of the unit with the tube which has the retention pin in place, so all 6 tubes can be filled. Remove that pin only when the assembly is placed on top of the dropper die assembly.

We Also Recommend
Also Available In Set(s)

New Products

Important Note
€3.00 Reward points
Important Note
€2.00 Reward points