These things just work great. I’ve tried a couple from other manufacturers and experienced nothing but frustration. Save yourself the headache they are a little bit more expensive than some others but mini mr does what it’s supposed to with minimal fiddling. Showed up pretty fast too. This is my third nine, 40, 45

This ran 230 grain FMJ .45 ACP bullets top notch.
It does not seem to like the 180 grain SWC cast very much. I think that is the fault of the bullets themselves as they seem to have a greater variance in diameter than the FMJ.

Absolutely love it, once adjusted it works perfectly. I have tripled the output of reloads compared to using my last bullet feeder.

I was a bit skeptical at first when a friend told me about his. So I went over to his house and tried it on a few 9mm loads. I was convinced after that. I immediately purchased one and have not looked back. It works great for 9mm and is very easy to set up and use.

What a great product! What a time saver

I was always worried about setting up the bullet drop die. It seemed either too complicated or too 'fragile'.

When the unit arrived I read the instructions a few time. It was obvious that this is a well thought out system and would work. Went to the garage and followed the directions and 30 minutes later it was working perfectly!

Waiting on more bullets to continue!

Have already recommended it to my friends.

Joe

I was hopeful this would be a cost effective alternative to the noisy electric Mister Bullet Feeder that I have on my 650XL (which works flawlessly I might add) I grabbed these for my Dillon 750XL. Also disappointed there is no solution yet to Powder Cop on new 750XL. Hopeful to have them set up ready to go.. WELL the huge downfall is the unpolished powder nose funnel flare gizmo; it causes terrible brass shredding and needs to be polished up. It is the ONLY one Hiccup on my Dillon 750XL causes a case grab for every case and basically causes powder to spill as well. I will will tweak it a bit more. Not sure I am saving any time loading the bullets either,...So Guess what, I went and bought another bullet feeder and put part of this off to the side for now. Maybe when I am loading just a few hundred rounds of other calibers but not efficient for thousands of 9mm .. Not totally unhappy but not as excited as I thought I should be. It is very innovative & EZ on the wallet if that's a concern.This is just not for my volume of loading. & Please polish the powder funnel I should not have had to to that.