.png)
.webp "Cardboard Targets")
27 Oct 2019
I bought it to mount it on a Dillon xl 650 press used for recharging the 9x21, an interesting tool even if not without a big defect, the plastic pad, it enters very precisely into the case and using very fine powder it remains attached for then fall on the shell plate dirtying everything, now I modified it by smoothing it to reduce its section and to create a camber on the end of the pad, I hope it goes better.
[DAA Reply]: As of Sep 1st 2021, the plunger tip is made out of brass which should solve issue.
[DAA Reply]: As of Sep 1st 2021, the plunger tip is made out of brass which should solve issue.
Lorenzo Gritti
22 Oct 2019
Works well, it’s a bit finicky and needs a lot of adjustments to get it right, even then it still beeps on the up stroke sometimes. Definitely gives you a piece of mind knowing I’m not under or over charged.
David Sweeter
17 Oct 2019
So much easier to use than the Dillon powder checker and more accurate and less expensive. I use this on my Super 1050 with an AmmoBot drive system. This is an absolute necessity for auto driven presses.
Joe Claflin
27 Sep 2019
Precise enough to avoid empty/low charge or double charge pistol cartrigdes with fast powders.
Tor Jørgen Tofte
8 Sep 2019
Nice product, easy to install does what it has to do
Luc Van Rompaey
7 Sep 2019
Great product! Switching from the Hornady powder cop die to this. Used it on a Hornady LNL to load 9mm and soon to be used with 223. Station 1 resize then prime, station 2 powder drop, station 3 DAA Powder Check, station 4 Hornady bullet feed and station 5 seat and crimp. I wouldn’t use a bullet feed die unless there was a powder checker and with the audible alarm you don’t have to watch a rod go up allowing you to use your eyes else where.
Willie Norman
