Write Review
Rating: (169)
27 Dec 2024
Easy setup and works very well!
I have two of these units for two separate tool-heads on my 750
I will buy another one when I get another tool-head.
They just work!
Barry Johnstone
26 Nov 2024
Your statement about this powder check not working on the FA X10 are incorrect, I have been using it on my X10 for 8 months now. You do have to simply remove the hardware from the left side of the powder drop, very simple. The Drop works just fine without it, I have loaded 20,000rds thus far in the 8 months since my purchase of this unit. I have been happy with the performance so far, it does through a little powder if you don't keep the end of the shaft clean, but it's not excessive.
Terry Beams
28 Aug 2024
Sensor and design works great, however spills powder all over the place the same as the Hornady control center one does.
tom rader
8 Aug 2024
The product as made is useless on .223 or any small mouth cartridges. The rod, correctly installed per instructions, moves too much side to side and catches on the mouth of the case, making is useless for powder checking. It appears the plastic insert for rifle use allows way to much movement of the powder check rod. If, possibly, there was a way to hold that rifle insert piece snug against the die, it could possible keep the rod from moving so much. Problem is whatever the weight, it could not be magnetic. There needs to be a fix to make this a worthwhile powder check for .223/5.56 cases.
Kelly Edmondson
1 Aug 2024
Create product that gives peace of mind. Using on Lee Ultra and six pack. Relatively easy to set up, although some sort of threaded feature on the magnet adjustment would make it easier to fine-tune. I would not recommend it for the finer powders like shooters world, major pistol. It makes a mess gets into your shell plate rotation and primer slot. Air movement and vacuum moving in and out of the brass along with it sticking to the plunger. Tight group, similar disc shaped powders work awesome. For super light loads like tight group in 9 mm I wish the range could be tightened down a little bit. You’re gonna have to live with monitoring a light/empty load or a heavy load but not going to get both since there’s only 3-4 grains total. Overall great product and like I said, it gives peace of mind.
Tim Kenworthy
31 Jul 2024
Easy setup and works very well!
I have two of these units for two separate tool-heads on my Apex10.
I will buy another one when I get another tool-head.
They just work!
Michael Schene