.png)
.webp "Cardboard Targets")
22 Apr 2022
works well for me, I apperciate the little bit of extra room it creates beside my press.
Mike Brownfield
15 May 2021
Opening should be a little bit wider so it could allow 40SW not to hang ocasionally .
Some sorte of angle regulation would also be nice...
Some sorte of angle regulation would also be nice...
Hugo Simoes
5 Mar 2021
This looks awesome, but will only work if you have a strong mount under your press. I do not, so I cannot use it.
Kurt Hargarten
1 Feb 2021
This is the best $20.00 you can spend if you are loading on a progressive press. I now have two of these units set up so that as the loaded round ejects off the press I can grab it if I want to conduct a random OAL and case gauge verification but if not the spring assembly takes the loaded round to a 30 or 50 caliber plastic ammo can with a 5/8" hole drilled into the top of it to store the rounds until I check them on my HUNDO 100 rd. cases gauge (that you can also purchased right here at DAA). I have loaded about 4000 rds so far using this system and LOVE it.....No more having to stop on a long load run to empty the loaded bullet bins.
IMO - for the value this item brings it is way under priced. Fits on all Dillon progressive loaders as well as the Mark7 Evolution and Revolution series and is not as bulky as the larger 3-D printed Output Chute that requires a 2" tube attachment.
IMO - for the value this item brings it is way under priced. Fits on all Dillon progressive loaders as well as the Mark7 Evolution and Revolution series and is not as bulky as the larger 3-D printed Output Chute that requires a 2" tube attachment.
Mark Dillon
27 Jul 2020
The idea is nice, but even with a gradual slope I ended up with rounds setting eachother off. As the round goes down the spring it picks up a good amount of speed and smacks into the loaded round bin. Scared the crap out of me and sent shrapnel everywhere.
Jack Whelan
14 Nov 2019
Cool and fun add-on works great for my 9mm and 223 reloading.
Nick Brunelle
