DAA Output Chute and Spring

Double-Alpha Academy

Key features

Configure
22.00
Save for Later
€1.00 Reward points
(12)
 Item in Stock | Usually dispatched within 24 hours

Latest reviews

Blake ***
Monday 04 December, 2023
Angled 20* too shallow to be used on a Dillon RL1100. Rounds get stuck in the plastic part of the chute and rarely go down the spring. I'll be ordering a different option.
Rating: (3 of 5 Stars!)
George ***
Sunday 03 December, 2023
DAA Reply: we don’t believe any static electricity that could build up during the sliding of the bullet down the spring could make the round go off.
Possibly an impact on the primer could do that, so it is always wise not allow to rounds to slide too quickly down the spring – best to angle it so...
Rating: (1 of 5 Stars!)
Kevin ***
Friday 17 March, 2023
I’ve been running a Hornady LnL with a Mr. BulletFeeder, and it turns out loaded rounds so fast I’m forever managing/emptying the output bin. Upon purchasing/using the DAA Output Chute & spring, I discovered that this inexpensive item has been some of the best money I’ve spent in a long time . ....
Rating: (5 of 5 Stars!)
Craig ***
Friday 03 March, 2023
Works just fine on my Hornady AP. No more overflowing bins in a long loading session. This directs everything to a large tub I placed on the floor, and i deal with everything at the end. Great!
Rating: (5 of 5 Stars!)
Gordon ***
Tuesday 26 July, 2022
I couldn’t get it to not jam up. I tried putting the spring all the way in and out and no difference. I’m going to use the spring with my rollsizer instead of the tube.
Rating: (3 of 5 Stars!)
Mike ***
Friday 22 April, 2022
works well for me, I apperciate the little bit of extra room it creates beside my press.
Rating: (5 of 5 Stars!)

Description:

The DAA Output Chute can be attached to any reloading press, hanging onto the same bracket which usually holds the Akro-Bin, and replacing it.

The long, 120cm (47") feed spring enables you to run the ammo down to a container on the floor, sparing you the need to empty that bin as you reload, and uncluttering your reloading press.

This Output Chute is also designed to clip on below the output ramp of the DAA Automatic Brass Marker, and can be used there to output the ammo down to a container on the floor or below your workbench.

This Chute has been tested to work perfectly with all pistol caliber ammo (9-40), although some types of 0.45 bullets have been seen to hang up occasionally. It works well with .223 rifle ammo too. It is designed to handled loaded ammo, not brass, which is more likely to hang-up.

 

We Also Recommend
(3)
Important Note
4.95
€0.25 Reward points

New Products

Important Note
16.95
€1.00 Reward points
Important Note
58.08
€1.00 Reward points
(2)
Important Note
129.95
€3.00 Reward points
(1)
Important Note
465.85
€6.00 Reward points
Important Note
119.95
€3.00 Reward points