Product Reviews

I’ve only had this unit for about a week. For 40S&W it’s amazing. It’s quite easy to setup if you read through the manual. I’ve run 2k 40sw cases through it thus far. Took a whole 5 minutes to do. Takes the glock bulge out of case with ease. I haven’t found it quite necessary for 223 yet. Seems all my range brass don’t have much bulge at all. It definitely takes some pressure off the progressive press while loading. I still lube the cases, but it glides right through the sizing process. For those having trouble with the frame rails being “bent” and uneven, loosen the bolts and nuts holding the frame rails to the gearbox. There’s plenty of play in the holes and it’s easy to level it out. Cosmetically, the machine could use a little more quality control. The frame rails are flimsy for a $2k investment. And no this is not to “protect your investment” during shipping as the manual states. There are minor scuffs and what not, but really not bad at all. I will say the welds holding the case feeder bracket to the frame rail is bad.... real bad ????‍♂️ A little embarrassing for the price point. Like I almost went into the shop and built a new frame for it kinda bad. The gearbox is not blue as shown in the photos. Kinda sad as it looks better with the blue instead of all silver, but it still works. All in all, this is a fantastic design. The machine functions great and very efficient. It’s such a short step to add to the reloading process and with great results. I doubt I’ll even bother to gauge any of my finished rounds anymore.

Works flawlessly. Very pleased with my purchase. A great addition to my 750xl.

Fast shipping and I like the way i can change pistols quickly.

Shipped quickly and received on time. Great to do business with.

Good system! I just have STI's that need to fit, but if I ever get a different brand, I can just order a new block.

received my tool holder for my dillon xl750,puy it on and the tightened the screw ,then put my most used tools on it and it would fall down as i would use my press, ,easy fix ..What i did was put it back in place where i wanted it ,then i put a small zip tie around the case feeder pole underneath the tightened part..works great now..doesn't move..still a good product..thanks Double Alpha