Product Reviews

I Purchased Mr. bullet feeder for my Dillon XL 650 and I have to say I am very impressed. Set up was not difficult and once I had a dialed in my output went up dramatically.

I installed this die on my XL 650 so I could keep my powder check system while also using Mr. bullet feeder. It did not take too long to dial-in, I highly recommend this product.

The items were just as expected and were cheaper than found on other sites. It pays to order from the company that sales the product to the other distributors. Shipping was quick, almost overnight with standard shipping requested. As a side note, if you use a chronograph it is only a matter of time until you or the person you loaned it to, damages it. I will not hesitate to order from Competitive Edge Dynamics again when needed.

It works better than the Dillon but it did not go deep enough for my use. Sometimes the bullet falls off Right before it bells the case the funnel is enlarged. But the enlarged portion was not deep enough. I will put it in a lathe and extend the .358 portion of the expander another 5 or 10,000ths.

I haven't used any of the other bullet feeders out there,but after getting my Mr. bullet feeder and getting it set up I wouldn't buy anything else. This system is very well thought out,works perfectly,adjustments are a piece of cake, and unit is very compact for when space is an issue. Great product!!! NOTE; I did have one issue when setting up the unit that needs to be addressed in future production runs. This has to do with the mounting bracket set up. There is an issue when assembling the vertical rod into the round mounting puck. The problem has to do with the radiused ends on the vertical rods. When the vertical rod is assembled into the bottom puck where it bottoms out against the horizontal rod,and the set screw is snugged up it engages the radius on the vertical rod and pushes it up out of the puck. The simple fix was to just grind the radius portion off the rod end so it will have full contact with the set screw.The best fix would be to just re-position the threaded set screw hole a little closer to the center of the puck to avoid contacting the radius on the rod end. Great! compact easy adjustment 5-STARS John

Smooth release. Tension wrench on the back. Work fine with all kind of single stack .45 acp mags I've tried. Good product ! -- Sortie de chargeur sans accroche. Tension réglable avec une molette. Fonctionne avec tous les chargeurs de .45 (single stack). Très bon produit.