Product Reviews

I bought it to mount it on a Dillon xl 650 press used for recharging the 9x21, an interesting tool even if not without a big defect, the plastic pad, it enters very precisely into the case and using very fine powder it remains attached for then fall on the shell plate dirtying everything, now I modified it by smoothing it to reduce its section and to create a camber on the end of the pad, I hope it goes better. [DAA Reply]: As of Sep 1st 2021, the plunger tip is made out of brass which should solve issue.

I purchased this Mini Case Feeder for my 650 because $300 is too much for the Dillon case feeder. I wasn’t expecting it to work as well as it did to tell you the truth. I was so pleased after the first use, I immediately bought another feeder. During the loading session, when i’m using the one feeder, I have my son filling the other. You can load 500 rounds in no time. I did have to sand down the adapter a bit to get it to fit onto my press, but besides that, the installation was simple. I am pleased with DAA products, and I would recommend them to anyone with a Dillon loading machine.

Not sure how I loaded before using this with a bullet feeder has made loading a breeze

excellant product, makes loading a breeze bullets fit consistantly

Works well, it’s a bit finicky and needs a lot of adjustments to get it right, even then it still beeps on the up stroke sometimes. Definitely gives you a piece of mind knowing I’m not under or over charged.

Works great. I bought this for my Dillon 650 to load 38 Special. I also have one set up to do 40 cal.