Product Reviews

I purchased this along with the powder check (you have to) It does the job very well.

This thing took a little fiddling with but ended doing the job on my lee loadmaster. I used to load 45 acp and it gave me confidence in the powder charge.

This product does what it is designed to do. I wish I had purchased it sooner. Pros: After over 5,000 cases run through it I have detected no "Glock Bulges". I chamber block test 100% of my loads. Cons: 1) Somewhat difficult to set-up. I assume the manufacturer intended the Rollsizer to be used next to your press using the press mounted case feeder. This did not work for me so I built a separate bracket for the case feeder. 2) There is no provision for an output bin or chute. Again, I assume the manufacturer intended the brass to fall into a bucket below the Rollsizer. I purchased a DAA Output Chute and Spring, made a bracket to avoid brass missing the bucket which will happen. 3) Be sure to adjust the feed tube so that 38 Super Comp brass will feed. If you don't the 38 Super Comp can bend the feed tube bracket. 4) While the motor, transmission and roller machining is very good the base bracket and electrical portions are primitive. At these prices I expected a little more refinement. I repeat, however, the product does what its supposed to do and I do recommend it to others.

I was originally skeptical as to how useful this would be for me. I keep a set of allen wrenches not 10 feet from my reloading press. I now find myself using these wrenches more than my original set. I wish I had gotten these sooner!

Works great with powder drop . No problems with brass sticking to funnel. I find myself using your site to purchase Dillon products.

My only concern is they dont hold a new roll of pasters. Otherwise they work as advertised