Product Reviews

Practical shooters: if you have become terminally frustrated dealing with bulged cases (.40 S&W, 9mm, etc.), this little machine may be the answer to your prayers. It's absolutely DISMAL when your high-output reloading setup sits idle, while you get old cranking one piece of brass at a time through a push-through die with a single-stage press! The Mini Roll Sizer not only removes the bulge, it does so with amazing speed and virtually no effort. Connect the Roll Sizer to your case feeder with the supplied flexible tube - then sit back and enjoy your favorite beverage while more than 1,300 healed cases per hour drop into your collection bin! OK, it's not cheap - but put one of these to work in your reloading room and you'll have a very difficult time getting the grin off your face! Many thanks to Mr. Kevin Whitehead (from Australia), who developed this little jewel.

With some competition pistol magazines costing upward of $135 each it's great to have an alternative to dumping them on the ground during a reload. With a little practice, slapping an expended mag onto this magnet during a reload costs you hardly any time at all...and saved all that wear and tear on your pricey mags. A great and useful device!

Great belt. Sturdy and affordable. Highly recommended!

I have quite a few of these, they are the only holsters I use for my guns.

I purchased this and I love it. It is so much easier to load my 9mm. I do have to keep an eye on them, not all the bullets flip over and some will go in upside down.

The conversion kit is well built, the only issue I have with it may be related to the caliber of bullet that I am using. It does not appear to flip my 300 blk bullets all the time, and when it doesn't they either fall out of the front the feeder or get caught up under the plate. [DAA reply]: Please refer to the following page for setup instructions: https://www.doublealpha.biz/support-mrbulletfeeder-rifle-caliber