Product Reviews

the tool holder does not fit the tube for the case feeder on my XL750, its loose, I had to wrap the tube with tape to use the holder. The wrenches don't hang straight in holder the holes in the holder are just a smidgen to large, a small beef but it bugs every time I look at it. The wrenches have a ball end that's a good thing but they don't work well, they bind up if uses at an angle, like the chrome plating is out of spec, just a little thick. I end up using my Bondhus set instead quite often. The closed end wrench works well but not on the powder measure, it wont go over the measure, an open end wrench would work better. All in all I wish I had purchased the Dillon set.

DAA reply:
Hi Kim,
Make sure the pole square-to-round adaptor is insert from below. It makes the fit tight on the round rod and prevent slide. But, as you have done, a little tape does solve that too
The wrench is a box-end wrench, closed design, as clearly shown. it must be closed to allow it to be so thin. And keeping it thin is critical to fitting in between the dies. cant have it both ways…. But sure, it does not fit over large items like powder checks. For that, you still do need an open end wrench.

this works very well, simple to use. combine it withe the feeder bowl and I don't need a $300 case feeder.

This loader bowl works well. I have been loading 6.5 Grendel, using the bowl set up for .223. The Grendel round uses the same parent case as the 7.62X39 so I was hoping it would feed the 6.5 cases, and it does. Just throw some cases in the bowl while the whole thing is sitting on the press and give it a swirl, the cases drop in just fine. This system is a better option than the Dillon case feeder for me, it's simpler to use and saved almost $300 on equipment.

Great training aid ... Well built , easy to install ..

Great gear, had one for .40, needed one in 9mm.. easy install and setup.

So I’m kinda stuck, this is a follow up to the 5 start I had given. I purchased this a year ago and it was awesome. So here I sit here a year later with a dead battery. I call my Batteries Plus store (3X to make sure) they tell me the battery has been discontinued. I call DAA and they check into it send me an email that says multiple locations on Amazon. All the feed back for the amazon ones are crap or are completely out of stock and are from another country. So until DAA can make good on a reliable battery availability state side. I wouldn’t recommend this powder check.

DAA reply:
Hi David,
Ok, since you don’t want to purchase from the amazon links we sent, here is another:
https://www.hellobatteries.com/other-alkaline-batteries-4lr44-10-11-23-27a/alkaline-battery-1-x-11a-mn11-6v-gp-battery-4891199003776-354.html
hope this helps,