Product Reviews

Great Idea! Priced Right, but a couple of design issues. 1) Goes through batteries pretty quick 2) Small Pistol primers do get a little stuck at the drop hole, You have to pop on the lid 3) Primers can 'flip' with lid closed 4) the serrated base doesn't do a very good job of flipping all primers. Should have used the Lyman round flip tray specs for your internal floor pattern design. Finally, I wish the lid 'locked' down, a simple snug fit would help.

I was on the fence about purchasing the roll sizer and conversions. I've been reloading for 30 years for 9mm, 45ACP, and others, and never had an issue with case base bulge with the brass I had. Then again the brass was shot in 1911's for the most part. Late last year I purchased some range brass and had chambering issues with my setup that I never had before. This unit solves that problem for the most part with a few tweaks to the resizing die. It is an extra step, but to me it's worth it, and it is peace of mind for brass with an unknown history.

I have used tarps in the past, and this is way better. Doesn't really move in the wind. Haven't used the pocket for weight, but it's a nice feature to have. Shipped quickly, and lower priced than a mesh tarp from others. A good buy and does the job.

Must have product, perfect size (big enough) for separating steel media.

Haven't used the bullet feeders before , so I bought the feeder die to try and it works better than I expected. Was easy to set up and just sets a single bullet on the case .

This is the best $20.00 you can spend if you are loading on a progressive press. I now have two of these units set up so that as the loaded round ejects off the press I can grab it if I want to conduct a random OAL and case gauge verification but if not the spring assembly takes the loaded round to a 30 or 50 caliber plastic ammo can with a 5/8" hole drilled into the top of it to store the rounds until I check them on my HUNDO 100 rd. cases gauge (that you can also purchased right here at DAA). I have loaded about 4000 rds so far using this system and LOVE it.....No more having to stop on a long load run to empty the loaded bullet bins. IMO - for the value this item brings it is way under priced. Fits on all Dillon progressive loaders as well as the Mark7 Evolution and Revolution series and is not as bulky as the larger 3-D printed Output Chute that requires a 2" tube attachment.