Mr.BulletFeeder by DAA Die Assembly Only

Manufacturer
Double-Alpha Academy

Mr.BulletFeeder by DAA Die Assembly Only

Key features

Configure

Caliber

.223 .308 .40SW .45 6.5x55mm 9/38S

$57.95

4 payments of $14.49 with Sezzle

Qty:

Save for Later

(153)

in Stock

Latest reviews

Dean ***

16 Feb 2021

I'm placing them on my Dillon tool heads and using the feeding tubes for the bullets. One for 38 super comp. One for standard 38 super. Two for 9mm. One for 40 s&w.

Rating: (5 of 5 Stars!)

Michael ***

13 Feb 2021

It just works every time regardless of bullet type. Lead, jacketed, or powder coated this die works flawlessly every load every time.

Rating: (5 of 5 Stars!)

Mike ***

10 Feb 2021

Purchased the 9mm/38S, the .40SW and the .45 have only had the opportunity to use the 9mm/38S model so far. Each size is identical with the exception of the inside tube's ID it seems to me. Once installed and adjusted properly, the 9mm performed flawlessly. Am very satisfied with this MBF...

Rating: (5 of 5 Stars!)

Wes ***

1 Feb 2021

Haven't used the bullet feeders before , so I bought the feeder die to try and it works better than I expected. Was easy to set up and just sets a single bullet on the case .

Rating: (5 of 5 Stars!)

Bernard ***

28 Jan 2021

Loaded a lot of rounds in 9mm , 40cal, 10mm and 45. Excellent tool.

Rating: (5 of 5 Stars!)

Mike ***

14 Jan 2021

I added this to my Dillon RL1100 and it works great. It's much easier for me to drop the bullets into the top of the die then set each one on the case. The die will hold three or four bullets (9 mm) so it does speed things up. I just ordered the mini feeder to go with the die.

Rating: (5 of 5 Stars!)

We Also Recommend

Mr.BulletFeeder by DAA Die Assembly Only

$57.95

Add to Cart

Mr.Bulletfeeder Bullet Dropper Thread-Extention

Mr.Bulletfeeder Gen 1/2 Bullet Dropper Thread-Extention

$17.95

Description:

The Mr.BulletFeeder die assembly is the “clever” part of the Dropper, the part that allows only one bullet to drop while retaining the rest of the stack.

Made of Anodized Aluminum, this assembly is caliber specific and includes a threaded die body, an inner aluminum dropper tube, a nut, clip and 3 steel balls.

This assembly is the same item used for both the Mr.Bulletfeeder and the Mini Mr.Bulletfeeder by DAA.

These Die assemblies are sold separately, to enable you to set up a 2^nd tool head, leaving the die correctly adjusted on each. If similar calibers are in use, such as 9mm on one toolhead and 38 on a 2^nd, you can transfer the upper part of the dropper from one to the other, leaving only the die on the dedicated tool head, permanently adjusted. This will save you buying a complete new dropper for the 2^nd caliber, and also mitigate the need to detach the wiring and the feed spring from the top of the dropper assembly as you switch over calibers..

We Also Recommend

Mr.Bulletfeeder Gen 1/2 Bullet Dropper Thread-Extention

(3)

Important Note

$17.95

$0.50 Reward points