Product Reviews

The zippered corner pockets for heavy sand work great, no need to find rocks or pieces of concrete to hold corners down. Unlike an ordinary tarp, this one won't lift in the wind and stays put because of the mesh material used.

Perfect size. Well made. Built to last. Will buy again if needed. Can’t roll size with out it.

I have since bought several more items. Tom has been extremely helpful and easy to work with. Even with all of my questions. He was patient and made sure I had all of my questions answered before placing my orders. Excellent communication and fast shipping. Thanks Tom!

Beats the heck out of loading 1 case at a time. Take a handful at time and shake them in. Works great and loads reliably.

Mine came with the mini case feeder, however it was not threaded at all, so I used a 3/8"-24 tap to thread it onto the XL750 cam pin/rod. Like in the description I did have to dremel out both pieces and then sand them with sand paper a bit to smooth them out and to get it to get a good fit the 9mm case feeder tube. It fit my 223 tube just fine. After that worked great with the Mini Case Feeder and the loader bowl.

I have always been an RCBS and Hornady machine user, just what I started with and have gotten comfortable. As such I didn't often venture too far from RCBS, LEE, Hornady or Redding for my dies and accessories. After spending $200 on failed bullet feeders from RCBS and Hornady I stumbled on Mr Bullet in a Dillon thread and boy am I glad that I did. I now have all four or my progressive presses setup running Mr Bullet and it NEVER fails. The worst that will happen is a double drop and a simply raise of the die will resolve this for good. This can happen if you set with just a few bullets and then run a complete tube in production mode. The design is so simple but so very effective. A spring is a good add and helps it return each time. I use a 2" long x 1/8" diameter fairly week spring connected at both ends on the retainer clip stretched downward onto a short machine screw threaded into the side of an RCBS lock nut threaded onto the die above the original that locks to the die plate. Super simple, clean and does the job. Mr Bullet has an add-on that is dual spring and probably better as it would apply even pressure on the inner die tube. I especially love how I can easily switch over calibers and run the same bullet drop die especially with the 9mm, 380, 38s and 357 mag. The dies are very reasonably priced so having one for everything you do is not a problem. And you don't need a bullet tube array for everything you do just move it around as needed if you run multiple setups as I do. 100% support for Mr BulletFeeder. What a great product.