Product Reviews

I gave 3 stars for this reason. The inner belt is thin and the edges is a rough surface, not soft to touch. And the real kicker is the outer belt is Too thick that putting accessories is difficult to impossible. Case in point the reason I bought this belt is A: the company I usually use is out of stock at this time B: I was setting up a production rig and with this belt I could not put the Mag magnet on as the belt is too thick to fit into the holder.. Its a DAA magnet. Other then that good belt

I got 2 of the Psp Brushs for the dillon Xl750 thinking that I would need them as plate rotated around from the powder feed to bullet seating but in the end only needed one from the powder feed to powder checker as the dillon is so smooth :) they do work as the 9mm case is full and it keeps the powder in it

well what can I say about the caps... they work just cost a lot for what they are. they do keep the dust out and primers in the tubes when pre loading the tubes and hang them up on the rack

this make the loading area nice and tidy and you always know where the primer tubes are and none of this putting them down after filling just to find out that the primers of came out the top as I use the primerfill with it to fill the tubes to one end is always open. and this works great to load a batch of primers ready for loading

I got 2 of the powder checker as I have 2 Dillon 750 one set up for 9mm the other .44mag target loads . Dont need it for the 9mm as 5gr fills the case so a quick look you can see its ok or not but it takes that one point off the check list . Case feed . Primer. power ( no need ) bullet head . but as for the .44mag set up for 7gr in that case you can not see so before I got this I had to look with a torch through the die hole that this checker now fits. I feel a lot safer now knowing that the right charge is in the cases . it is easy to set up too

Even though I am not going to use with the Mr.Bulletfeeder as I don't load that much to need it. But for 9mm it make the bullet seat so much better so there is no Lead scraping as you seat the head into the case . it also sits there so not pinching your fingers into the dies lol very well done DAA