Product Reviews

This has been a marvelous upgrade. It eliminated the frequent jams that that were occuring in the case feeder. I can now run it at full speed for feeding my rollsizer. Before the upgrade, the feeder was very frustrating with cases jamming between the plate and the flipper ramp every few seconds. The ramp became more damaged with each jam, increasing the jam frequency until it was virtually unusable. I think Dillon's version is a bad design as it exposes the edge of the ramp to the case mouth where it can catch. The DA design does not. I also no longer get occasional jams at the bottom of the hopper either.

Put this on my RL1100 and it works as advertised. The Dillon factory wedge didn’t work well, the edge of cases would get caught on the edge of the wedge and stop the plate. Once that happens and the wedge gets a ding in the edge it will never work right. The DAA is a much harder plastic and shaped better. Ive run about 2000 rounds with it without a stop or an inside down case. Highly recommended.

The product is very good. Thanks to you, I'm using it well.

Because my C-more SlideRide no longer worked properly, I opted for the C-more RTS2. I doubted whether it would fit the gun, but after advice from Rien (from DAA). I ordered the dot and the mount. Ordered Sunday, delivered Tuesday. And indeed it fits exactly. No problem picking up the dot. It also sits lower on the gun (STI Trubor) and and looks nice…. Thanks DAA

Works great but I can’t use it because the two in one die did not work for me ?

I didn’t care for the way it works. It leaves the brass a little rough. I went back to two separate dies and t results improved immediately. I really hoped that the two in one would work because I have the powder checker. Now I can’t use that either?