Mark 7 PowderSense Wiring Kit

Mark 7

Key features

Configure
$10.76
$1.00 Reward points
Save for Later
(3)
 Item in Stock | Usually dispatched within 24 hours

Latest reviews

David ***
28 Aug 2024
Simple wire connects to all Mark7 auto drives… use it for whatever you want. Plug into the autodrive and connect the wire to whatever you can think of to shut off the machine. Make your own sensors. I connected the two leads to 4 pairs of wire using internet wiring. I then connect each pair to...
Rating: (5 of 5 Stars!)
Cyndee ***
4 Nov 2019
UPDATE this new photo[as of 11/04/ 2019] has been updated to the correct item my old poor 1Star feedback was based on a different image completely. Thank you for correcting the image. I hope someone will find the item worth 5**** My feedback steps up because of the effort of image correction. I...
Rating: (3 of 5 Stars!)
Cyndee ***
2 Nov 2019
Not sure why you ask me to write a review & when it's negative & accurate you won't publish so I will try again. You will NOT receive the item in the photo!!! You will receive a wire with a plug end ONLY this is a deceiving. Avoid this item PERHAPS they will put up a photo of what you are...
Rating: (1 of 5 Stars!)

Description:

The PowderSense® Digital Powder check sensor automatically stops the machine if an incorrect powder level is detected inside the case. You will then see a notification on the computer tablet to check the case powder level. A must-have for people that want full confidence that every round produced has the correct powder level.  

If you are using a Mr.Bulletfeeder use with a combo seating/crimping die. If you have a GSI bulletfeeder the PowderSense® can be used along with standard seating/crimping dies.  

Compatible Dillon Powder Check

 

We Also Recommend

New Products

Important Note
$99.95
$2.00 Reward points
Important Note
$26.95
$1.00 Reward points
Important Note
$30.00